Search results

  1. M

    Two Codes (P0327 and P0441): Need them gone becuase the car is sold...

    P0327 - Knock Sensor Bank 1 - Low Input Voltage I changed the knock sensors and this code still persists. My first question is what is Bank 1/A (i.e. driver's or passenger's side of the car)? As far as I can tell bank 1 or A is the LH side or driver's side. Could an exhaust leak cause a false...
  2. M

    The story of my first Disco HG job (with a final freak out)...

    So I dove in to do HGs, t-stat, water pump, etc. on the Disco about 3 weeks ago. Tore the whole thing down in a day and got the heads to the machine shop. Only struggle was the driver's side rear head bolt, but it finally came off. I then got really busy with school and did not have time to...
  3. M

    Putting the 03 back together after HGs...parts left over...need help...

    Ok. There are a few pieces from my HG kit that I did not use or even see for that matter. The most conerning are the 8 .25" thick by 1" in diameter rubber rings. There's 8 so, not valve train hopefully... Also, there are a few gasket and copper crush washers that I did not use. FYI, I did...
  4. M

    Where to buy: Lifters, Cam, Timing Gears/Chain...

    I have read around, but am an admitted noob when it comes to anything close to domestic or non-OHC motors. I have the '03 Disco torn down for head gaskets, head rebuilds, water pump, steering pump, thermostat, and maybe ABS shutter valve. Now that I am in here I am considering doing a cam...
  5. M

    Head bolt from hell...

    Any tips on getting the rear most, closest to the fender/booster, driver's side head bolt out. Mine seems to be torqued to 5000 ft/lbs. I broke a 1/2" drive and a swivel trying to get it out. I think the biggest issue is I do not have a straight shot at it. Suggestions...
  6. M

    Rocker Arm Question

    I see they are sold in LH and RH versions. Now is that referring to orientation on the shaft or the driver's/passenger's sides of the car?
  7. M

    Intermittent Three Amigos

    I've done some searching, but wanted to verify a few things... 1. Can you replace the ABS sensor without replacing the hubs? 2. What are the easy things to check first? My lights are intermittent, do not stay on at all times, and go out with an ignition cycle. 3. What is the spec for...
  8. M

    Did you buy an extended warranty? Glad you did/did not?

    Just as the title says. I am contemplating getting one, but I am also very mechanically inclined and have a shop at my disposal. I am trying to weigh the cost/benefit in my situation.
  9. M

    Came back to LR with my new '03 Disco: Intro, Questions, etc...

    Seems like you guys have a great forum going on here. I'm excited to contribute and continue to learn from you guys. I had a 97 Vitesse RR 6 or so years ago and that was a pretty bad experience over all. Air suspension failing, sun roof failing, basically nothing electronic working when we...