Can’t seem to find anything in the Workshop manual. Looks pretty straightforward yet always helpful to hear from someone who has actually done it or a diagram on what bolts, etc. to remove / location.
Thx in advance.
Thx in advance.
Thanks. So assume the bolts go to nuts welded in bumper?2 bolts. Like most things on the vehicle 13 15 or 17mm
Thanks. So assume the bolts go to nuts welded in bumper?
And the side bolts are for the end pieces?
Hum. Good point. Suggestions on removal? As I’m installing another one don’t have to be too careful.The real bummer is when you have a rusty one and the welded on nut breaks loose.
Thanks!If you can get liquid wrench or something similar soaking on it for a while first, do it. I had to grind off the head of the bolt on the last one I did. It is hard to do that without damaging the bumper. However, if damage is not a concern, I’m sure it will be easier. Id carefully use an acetylene torch.
Thanks! As a replacement is going on don’t need to be too gentle with the removal.Pretty sure you can squeeze a saw saw blade in there if need be.