I’m replacing the heater core in my 95 rrc softdash (which is the same as a D1) while I have my dash out. I have not removed the hvac assembly and looking for any suggestions.
Specifically, after removing the clamps at the core, the two hard lines going into the core seem very fixed in place and don’t move so I can just pull them out of the core to slide it out. I assume they are attached to the firewall somehow but zero room to even see them behind the hvac assembly.
Does removing the blower assembly give enough access or is there another way?
Any suggestions would be appreciated!
Specifically, after removing the clamps at the core, the two hard lines going into the core seem very fixed in place and don’t move so I can just pull them out of the core to slide it out. I assume they are attached to the firewall somehow but zero room to even see them behind the hvac assembly.
Does removing the blower assembly give enough access or is there another way?
Any suggestions would be appreciated!
Last edited: