Recent content by Chuckwagon976

Need the cats too.

WTB RRC/D1 full exhaust, preferably in the DFW area.

It also on land rover classic website. Part# ERR5474 is what I need, same as on a 94/95 D1

I think my intake is correct. All of my wiring matches up with all of the sensors on the front of the intake which I don't think are there on the other one you suggest, but I could be wrong. What I need is #6 on that second intake as the hoses I have are the same as in diagram. Those look like...

ERC 9119 This is the one I have https://www.ebay.co.uk/itm/325196307000mkcid=16&mkevt=1&mkrid=711-12763223570&ssspo=tL6NZLMlRP6&sssrc=2349624&ssuid=wqW4de1HR8y&var=&widget_ver=artemis&media=SMS

I'll check tomorrow.

Anything is better what I have now. PO made complete exhaust, one solid piece, from manifold to tail pipe and took the y down to a single cat right below the trans pan, so i can't drop it, have to remove the whole assembly. Just want a simple bolt up oem style without too much fuss.

My next thought was along those lines where maybe the heads were redone and older model parts used. Not sure about the coolant valve, where would it be and what would it look like? It has the fill tower with the brass screw down cap which was badly mounted, tabs bend to meet mount brackets and...

I have a 96 D1 parts truck and the hard lines don't mount up in the same spots nor do the hoses. I am hoping a 94/95 D1 with a distributor would be the same, just need to verify.

Do you have a 94/95 D1 as well to check if the heater hard lines are the same?

Good idea Robert. Mine has the fill tower you can see drawn in the 87-93 workshop manual coolant chapter but not there in any of the engine bay pics from the electrical troubleshooting for a 95.

Thank you very much

At this point I am trying to verify if the hard heater lines on a 95 RRC swb, are the same as on a 94-95 D1. They might be the same as a 95 LWB but I don't know on the 4.2. Mine on the 95 SWB are not original to 95. I know that 96 D1 and later are different because of no dizzy. The 94 lwb...

Does anyone have a 95 RRC swb and 94-95 D1? I need some help identifying if the hard/metal heater lines are the same. At some point po's of my 95 rrc swb changed the metal heater lines to earlier model lines. Just want to get it back stock because finding the right rubber soft heater coolant...

Title says it all. Is the cat y pipe from 94-95 D1 a direct swap/exact fit to a 95 RRC?