Recent content by jycsalas

  1. J

    How To: Replace Shuttle Valve Seals

    Don't know if this is already out there floating around. Hope it helps. http://www.landroverclubvi.com/abs-svs-seals.html
  2. J

    D1 front LT230 output onto D2 - what did you do about the low range switch?

    Are you saying that the DI housing doesnt look like the one on the left?
  3. J

    Need DI front drive shaft

    33178 Fl
  4. J

    Fan Clutch

    I finally did mine, here are the pics http://picasaweb.google.com/jycsalas/DIIThermostatModification# happy to report 182-188 city / hwy driving and occasionally hitting 190-193 during long idle but quickly goes down to 190-188 at idle. That surely beats high 190-210 idling. It used to be...
  5. J

    Replacing Ball joints on DII

    All the boots were ripped back when I bought the rig with 56k.... And come to find out, the lower joints were shot and extremely loose. I have done the pas side with no problems... Awful job to do though.
  6. J

    Anyone know where i can get this?

    Anyone know where I can get one of these cheaper than $30? http://www.roversnorth.com/store/p-3846-front-axle-steering-knuckle-collet-rr-p38a-discovery-ii.aspx thanks
  7. J

    Replacing Ball joints on DII

    hey guys i have been working on the ball joints for a while now... had some issues bending my original c-clamp and bought another one. thanks HarborFreight. i finished the driver side. what a PITA I did however run into some slight challenges as I had to grind two of the adapter to sit...
  8. J

    Removing the hub from the axle

    This is how I did mine http://www.landroverclubvi.com/front-hub.html
  9. J

    DI Windshield molding

    Hello fellas, I'm helping a DI owner with some various body work and need YOUR help. 1. The body shop will be removing the windshield to fix some rust at the top caused by a previous dealer repair from years ago. QUESTION: The three windshield finisher strips that surrounds the edge of the...
  10. J

    Fan Clutch

    TxDII, what hoses did you use between the thermo housing and the bleeder AND between the bleeder and the upper manifold? josh
  11. J

    Fan Clutch

    Well im sending my thermostat housing back for the smaller 1.25 size. that does look to be the best fit. I also ordered the same glow shift water temp adapter and a 1/8th npt petcock. But glowshift sent me a GREEN adapter.... =( I also have the lower BMW hose.... but I have a question where...
  12. J

    Fan Clutch

    NICE fellas... Im def doing this bypass ASAP. I looked at this too to make the bleeder setup. http://www.glowshiftdirect.com/36mm-water-sender-attachment.aspx Heck you can run a 1/8 NPT Petcock in place of a water temp unit for those of you running a scangauge. or buy this if you aren't...
  13. J

    3 Amigos solved - Virgin Island LR mod

    In my write-up i explain how to do several things. OPTION B specifies that you follow certain steps to do the repair WITHOUT removing any brake lines...or modulator completely. RE-READ Step # 38. Hope this clears it up
  14. J

    3 Amigos solved - Virgin Island LR mod

    SO..... My amigos came on today, 3 times!!! guess what it was...., my ground bolt after step # 44 came loose, so make sure it's tight!