Search results

Replacing the roto flex in my 95 D1 how would one go about removing the center bearings or what ever it’s called.

It’s in the drive line. When the shaft turns it slows and acts like it’s skipping a tooth and then catches it. I’m going to pull the rear shaft and see if the diff and t case turn freely.

95 D1 5 speed. Started having what appears to be a binding issue. Started a couple of days ago. Videoed the front diff noticed a catch and a clunk when it turned. Pulled the drive shaft videoed it again and saw the same thing with the rear drive shaft. It’s not every rotation but something is...

I picked up this on recommendation of a friend that’s a mechanic

I’m not sure. I had a shop put it on. What would be good to reseal?

Got myself a leak on my 03 D2. Started slow and kinda intermittent then got worse. It’s not from the bottom of the pump, this is how the last pump leaked about 6 or so years ago. This looks like it is coming from around a bolt so I’m guessing the gasket has failed. I’m going to tighten the bolt...

That's what happened to mine. No issues with steering just my diff angel.

My pinion angle was way of I could pull the plug on the diff and fluid would pour out. The bushings brought it down so I'm happy with that. The vibration I have is at 30mph. Pretty sure the one that's around 60 is in the rear its not bad neither is audible at most.

Yep, if it ever stops raining i'll get under it and check everything out. I did notice they had to replace a bolt and used one that's about 2 inches too long. That's just annoying.

I’ve driven it about 30 mikes and have more low speed vibrations than before and some about 60 mph. It cost a fortune to get this bushings installed and had a hard time actually finding someone to do it. Just need to sort out the vibrations.

Finally got the castor correction bushings installed and I need to have the truck aligned. Is there thing special with these trucks to align them? I've had my D2 for 17 years and never had an alignment even after dong a lift.

Ive been looking at them the past year. want to level it out when I'm pulling my camper. Look at SD Truck springs.

It was actually a fuse. All fixed up.

03 Disco Blower not blowing fuse is good can hear clicking in left side of dash that sounds like a relay. Controls light up as they should. Anything else I should check before pulling the blower out? A few years ago I did replace the ecu that controls the fan speed because it was only working on...

My D2 has over 200k on it. Had it since 06 i believe and its an 03 I run Rotella in and some lucas. I've replaced all hoses the radiator. The thermostat is from a TDI motor I think. Its gotten hot but never overheated. Tom Woods front shaft is really the only major upgrade I grease it semi...

I finally found someone to install these bushings on my 95 D1. will it need to have an alignment? I didn't have my D2 or this D1 lined up after installing new springs. Just want to make sure since its been a pain to find someone to install.

My rear left turn signal isn't working. Bulb is good switched from the other side, currently getting the fast blinking on dash like one of the front bulbs is out. Front and side marker are working. Is this bulb connected to another that could be out? Thanks, Eric

What connects to the connector?

I've got a 95 D1 and I have the SRS, Service engine, and the ABS. How can I read these and get them to go away? What is the full when cold on the expansion tank. Its black and not marked. I have a leak on passenger side I'm guessing its coming from the windshield any tips on fixing it or does...

Just got a new seat bottom it’s a leatherette one for my drivers seat. Do they just pull off and go back on?