Finally found some time to look further into this.
I have put a pressure gauge on to the pressure sender port and the oil pressure is fine. I have also tried a spare set of clocks and get the same two warning lights.
Its a bit of a mystery!
Going to try and find any cable damage on the oil...
I have checked the oil pressure and its OK. The temperature warning light is on as well but the engine is cold :-)
Engine is fine, just need to figure out why both warning lights are stuck on. Had a quick look at the wiring and cant see anything obvious
Hi Folks,
I have been struggling for a while with an older disco 2 I have parked up. It fires up instantly but the oil light wont go out.
I tried replacing the sender to see if that would help, but it hasn't
Is there a way of checking the wiring to the sender? as its a single wire, does it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.