Search results

The little plastic pieces that screw on to the headlight, that hold the headlight to the mount. Need 3 Tannks

Fixed. I tapped the battery terminals with a hammer a few times and it didn't work. Out of frustration I wacked the hell out of it and it worked!

Check Check Checked all of the regular clear ones. Not too sure how to check the bigger ones

See thread: 2000 d2. No pulse

Yesterday, I turned the key and all of the sudden everything went black. Some how, the bolt holding the negative battery cable has fallen off. I found another bolt to take it's place and screwed that back in. Went to in to start the car and there is still absolutely no power in the car...

Ok. So I have three different places i should put it now, the alternator, the engine block, and the frame. How about a definite answer? Can someone just follow their cable and tell me or show me where it goes? Mine has a Land Rover sticker on it saying it's the negative battery wire or...

Yep. Battery is fine. I've also had it on the charger while I've been trying to figure this out and it is at full charge now. But right now, none of the car has power. It's like a blackout.

http://i1094.photobucket.com/albums/i445/knighthead1/IMG_0071.jpg Ok this is what I'm looking at. The cable is extended all of the way and will not reach the back of the alternator. I'm assuming it connects to the vacant screw spot right next to the end of the cable on the alternator, but when...

Right on the top? I held the wire there and no start.

I found it dangling this morning. It's my dad's disco and I just inherited it so I'm kind of a newb. Thanks (2000 d2)

Whoops please ignore thread. Wrong board

I found it dangling this morning. It's my dad's disco and I just inherited it so I'm kind of a newb. Thanks Edit: 2000 D2

Bump still have it

Just put it on my truck to test, works like gravy.

Holy cow. I'm pretty sure it will fit in a standard size box so I'm not too worried.

Ups

I'm going to put it back on my truck tomorrow just to be absolutely positive. I will let you know.

Used good condition. Hydraulics work. Ready to go. $75 Shipped to lower 48

Replace bottom drain valve with a fitting, section of hose and a valve. Bleed water out once a month or so. Those crappy shop compressor drain valves will either get stuck closed and you break the tangs off or leak. Plus they are inconvenient and discourage maintenance. I leave mine pressurized.

"The Left Behind books are fiction but are read as truth by a lot of evangelical christians... Imagine a world without oral sex. " If the above is true of real believers, then "The entire world will be very surprised at the large minority of people who were here one second but disappeared...