I have a few open containers for LR3 fluids. Mostly leftover from the last fluid exchange. Rear Diff (locker), Tcase, almost a full jug of orange rad fluid etc. I won't be needing any of these so if anyone wants them LMK asap and i'll put them aside otherwise its all getting recyled.
All parts are new in box except for the height sensor (used working take off) and the Lynx diagnostic software.
Genuine Land Rover
Hose pch 501084
Hose pch 501094
Hose lr006158
4 seasons
39448 a/c expansion valve
Bearmach fug500010 (tailgate actuatot)
Lynx Diagostic software (unlocked for...
As you may have saw from my previous post I’m parting a 99 D1.
I’m about finished taking what I need and a few others have stopped by and grabbed some stuff but there are stl a bunch of good parts available.
All remaining parts are $20ea. I’m willing to ship anything that is easy to box...
I have a straight and 95% rust free body and chassis plus some extras. $300. Will post detailed pics once the axles are pulled. Body is a 1999 SD model.
I really hope someone can use this. I was going to cut out the front section to pull the engine and trans as one but decided it would be a sin...
I'm pulling the transmission from a D1 to use on a project. Do I need to remove the shifter from the console before dropping the trans or can I just drop it all at once? The shifter is going to be reused so I don't want to damage it when removing the transmission.
Do you need to drop the oil pan to remove the bolts to the torque converter? I’m trying to pull the engine but having issues reaching the bolts to the converter.
I picked up a non-running D1 to use the drivetrain/suspension/steering/etc for a project but after looking closer at the car it's pretty clean so I want to give it an opportunity to live on before I start tearing it down. I don't know the history of the car other than it was parked a few years...
211k miles
We bought this car preowned in March 2005 with 3,500 miles. Was the wife's primary driver until Nov 2021. My son has been driving it since March 2022. Regularly maintained. Upper/lower front control arms/tie rod ends, etc replaced last summer. Front/Rear Brake rotors/pad replaced in...
Anyone know the dimensions for the bleeder screw o ring on the expansion tank? Part # LR007315
Will check the local dealer but they don’t stock Jack so I was hoping someone may know the size so I can check the local hardware store
Anyone know the test procedures on the trans temp warning light?
Light is on even on a cold truck. Learned there was a sensor at the trans cooler and one on the Tcase. Trying to determine which sensor is turning the light on. Unplugged them hoping unplugging the bad sensor would shut the lamp...
Trying to fix the anti lock light on a 97 D1. Ran the blink code and it show 3-1 (open circuit to the solenoid).
Hawkeye is showing fault 30 Inlet Valve Right Hand Front Power amp electrical connection interrupted and Fault 36 Inlet Valve Left-hand Rear Power amp electrical connection...
Just over 170k on the wife's '05 LR3 and I want to do a little preventative maintenance since we do take it on longer trips. I've been on top of fluids/joints/belts/etc but haven't touched the water pump and pulleys. From what I understand the water pump is well designed so I may just leave it...
It's time to replace the front wheel bearing/hubs on the LR3. Are all hubs created equal or is there a specific brand I should use? Not looking to cheap out but don't see the need to spend more than we need too either.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.