Search results

  1. logan_gibson

    Found! - Range Rover Classic LWB Step-side runner (STC8160AA)

    Do you need the whole kit or just the runners?
  2. logan_gibson

    Safari Gard D1 vs D2

    Just call and order the D1 stuff, https://safarigardllc.com/ For the most part D2 and D1 front bumpers will bolt up - just may have some gaps/body work to do. Rear bumpers are different.
  3. logan_gibson

    2 Button Lucas Key FOB Land Rover D1, American

    I've got one, shoot me a PM with you address and I can get you a price shipped.
  4. logan_gibson

    RRC drivers seat

    Give Scotty a call over at Enigma RnR, he should have some. He is over in Orlando, FL area (407) 720-9450
  5. logan_gibson

    Has anyone replaced their A pillars on a D1?

    Never attempted it or seen any postings about it. I've got some good pieces if needed, I can chop them off and put them in the mail.
  6. logan_gibson

    Factory(?) D2 brush guard for winch tray

    I believe these are the part numbers if it helps in any way, sold one recently to a guy here in town. - Winch cradle. (LRNA31766) - Wrap Around Brush Bar for winch kit (STC7694) I can message him and see if he is interested in selling it, not sure the price but it is located in Alabama.
  7. logan_gibson

    Transmission leaking badly - options...

    A lift isn't needed, I've dropped 3 out in my driveway using a floor jack and jack stands/wood cribbing. Yes, once you have the y-pipe out of the way, just remove that tcase and then the transmission.
  8. logan_gibson

    Hood Release Cable

    Installed a Britpart on a 99 D1 last year, Had no issues out of it. Have one on my 97 D1, again no issues.
  9. logan_gibson

    Wiring Hella Light to Aux Switch

    Yeah, I believe your issue is that the switch isnt latching. So its acting more like a button and only completing the circuit when you hold it down. Not latching on/off. I have the correct switch (and wiring), I can ship it just shoot me a PM.
  10. logan_gibson

    Wiring Hella Light to Aux Switch

    Does the switch stay in position, or does it act as a button and go down and back up when you release?
  11. logan_gibson

    Seat bolt pattern

    Attached to a bracket in the center console. Sorry for the cruddy photo, lens is busted on my phone. But I believe this is the mounting point where the latch was attached.
  12. logan_gibson

    24 spline diff D1,RRC,90

    3.54 is stock D1 gearing correct? I have one in a 94 D1 I can pull out if so. 136k on it. Would be shipping from AL though.
  13. logan_gibson

    WTB : Disco II Front Grille

    I've got a silver one, can ship it from AL. Just shoot me a PM
  14. logan_gibson

    D1/D2/Defender/RRC Off-road & Spare Parts

    Are the OME 2766 coil springs HD ones for a D1? IF so price on those and the brake lines shipped to 35907?
  15. logan_gibson

    1994 D1 Part out, with a few D2 things.

    No I dont, sorry.
  16. logan_gibson

    Gas tank guard

    Pm.sent
  17. logan_gibson

    Please help me understand

    Are those not some sort of spade connector inside the black plastic housings? Couldn't you remove the heat shrink to see how you need to connect the new wires and make one? Looks fairly simple.
  18. logan_gibson

    REAR CARGO ACTUATOR

    I think you have the wrong photo attached.
  19. logan_gibson

    Best diff guards for D2

    https://discoweb.org/oldsite/
  20. logan_gibson

    Best diff guards for D2

    Not sure if the best, but should beef it up a bit. https://gwynlewis4x4.co.uk/product/hd-weld-on-diff-pan-diy/