I have had good luck with the medium spring Terra Firma 2" lift with 32" tires with the Camel Cut. Plenty of clearance and as has been mentioned - much less to deal with than going with 3"!
Just wanted to thank everyone in this thread for getting to the root of this problem! My headlights and dash lights have been pulsing for a couple of years - and I finally decided to do something about it - found this thread, ordered a new voltage regulator off of Ebay, installed it (really...
I'm sure many of you have done this. I had an incident where my airbox tube to the plenum got displaced due to torque - and was informed that this is probably due to a bad motor mount. So I purchased both mounts and am looking at the drivers side mount and wondering how best to replace it. Easy...
I have a '99 SD - white also! And I have the same ticking - comes and goes. Haven't tracked it down yet. Working on a new motor - so not a priority at this point, but sure wish I knew what it was...
Finally getting back on here - wow - will definitely check the motor mount - could be the culprit. Prepping a new engine this winter - so they will be replaced soon anyway. Thanks for the feedback!
SOLVED: I did get a Hail Mary! It was the rubber tube that goes from the air box to the plenum. It slipped off. Put it back on and retightened the retaining band and all good. Sure cheaper than a new fuel pump! Wish I had seen that when it happened - but it was barely noticeable. Good to know if...
I am hoping someone can help me figure out what happened to my disco. Let me preface this by letting you know that there were no issues prior to this - my engine has been running great.
I was going slowly up a pretty rough, steep rocky road and eventually stopped and engage the center diff to...
Anyone put an arb awning onto their safety devices rack? I just ordered what looks like the best of the 4 mounting kits available from Arb - and it doesn't fit the space of the bars on the rack. The mounts are 4.5" apart and the bars on the rack are 3.5". I would rather not have to drill holes...
Wow - the crower certainly sounds perfect - maybe I'll do that...
"Crower Power Compu-Pro camshafts offer more power with an extended rpm range for your stock or near-stock engine, plus enhanced mileage. These camshafts show strong low-end and midrange power for spirited driving on or off-road...
So I am in the middle of a rebuild, and am going to need a new cam. Anyone like to suggest something that they are using (other than OEM) that they are happy with? I understand that different cams do different things - so I guess I should clarify. I am mostly "overlanding" with a 2" lift and 32"...
I had a severe death wobble on my D1 - even after replacing all of the tie rod ends and bushings. i was stumped. I finally figured out that it was indeed the pan hard bar bushing - must have put it in wrong or had a bad one, because after purchasing a new pan hard bar and installing it, it was...
OK - I have fixed my idle issue! It was a bad Throttle Position Sensor. Replaced that and now it runs great - especially after having reset the adaptive values.
Whew!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.