Search results

D1 headlight switch, Dont care what color to Philly area. Peter

sounds like a dead cell in the battery, EACH of 6 cells is good for about 2 volts, Alot of times if 1 cell is bad, A jump will NOT help. Try a new battery, If still no, Whack the starter a few times with a hammer and try again. Peter

Did the Jiggle thing, I was 60 miles from home, In the dark with no headlights or running lites, And No tools, I did however has a S&W screw driver, I carefully TORE out the witing for a set of roof rack lights, And ran them to 1 headlight, Then tore some other wire to make a jumper between the...

I was out in the eve for the first time in the 97 dicso, and I noticed that the road was looking dark, I was without tools and electric meter, But the headlights and left side running lights were out, The right rear running light is all I had, Dash lights okay, all other lights out, Brake lights...

Truck is a 96 5 sp with the 4 coil packs I have had my 97 disco through heck and high watern never issues like this Truck is in near showroom, Mine is not, I was thinking that truck has 124K miles and that is when my fuel pump went bad,,,, what do you think, Fuel pump or filter, All...

This is a used Disco that is priced right, But VERY clean, Thinking of replacing my beat up trail truck with non beat up trail truck I will go there tomorrow with a pressure gauge, If i remember correct I am looking for about 35 psi on the fuel The cats are fine, Exhaust modulates well, so no...

I am wondering why a D1 with 5sp would sputter under load, and had a hard time passing 3000 rpm? If you baby it you can reach higher rpms, But if it is at 2K and you floor it, It will not accellerate, Just miss and skip till you let off the gas to just about 10% throttle. What could it be...

Pump is now on, new hoses and new power steering box, But occasionally acts like no power steering, but 2 minutes later working fine, remover steering damper, still same issues!!! Replaced all these parts due to serious leaks, at stop, it would flow 1 pint in less than 30 seconds, so i...

How do i remove the stock 3 bolt flange from the stock pump, The new one doesn't have any pully mount, I tried to pul it off with a 3 arm puller, No dice, I even tried heat, The new one has a smooth shaft, so i dont think it's threaded on there, Please, any more imput??!!! Peter.

I bought the 20874, and it does not come with the pully mount, Just a shaft, What do i do now, Also the return line faces the pass side, not down, Will this present an issue???? Peter.

Will fit in a 97 disco, I am in need of a new PSP for my disco, and i found that in the mid 80's there are about 4 different pumps used on a chevy s10, Can someone please let me know exactly which one i will need! I have a serp belt if you need to know! Thank you! cannot drive truck now, It...

fit into a 97 disco, Need a new one shortly, current one making alot of noise! Peter.

I have all 4 doors for a 1988 rrc, they all are dent free and in good shape you must pick up in the Philly PA area, all glass in doors, all poewrs work but the driver door, they are white! Peter 215 778 5301

On sunday in the philly area, I have a 1988 rrc that will be picked apart for free, Please see Range rover tech section for details! Peter.

I have a 1988 RRC, which the floors have rusted out, and it is going to be parted out this weekend here in the Philadelphia area, If you need some parts, come by and expect to pick em yourself, so bring what you need to do so, This truck runs fine, no real problems, The 3.5 engine is already...

If you already have the compressor on, and pressure is up, How long does it take to lock in??? And how long to unlock? Will the ARB be able to unlock if you are in a turn already? Peter.

I agree with Jen, Please dont spend money on an umbrella made of window screen Just trust in the force,,, Done buy a new drive shaft unless it is a DC one, Just tossing your money away, I will give you my address incase you would like to toss more! Visit rovertym and read! Peter.

The vw rabbit has an oversteer issue, not an understeer issue as many front wheel drives have, They designed the rear to break before the front by making the front suspension softer that the rear, >>> go into a turn at speed, and the front tires remain on the ground, and one rear tire will...

rear bumper is good, missing 1 end cap. Peter

Dont forget, with each item pulled, you get to take some free seasoned oak for that romantic fire for your significant other! May 6th+7th Peter junkshopcafe@msn.com