Search results

Got one. Thanks to all

Rock auto is out of stock and unknown if they will have again.

Anyone have a drivers side front abs sensor? I have a 1993 LWB.

My 1993 LWB has not had keyless entry since I have owned it, bought it this year. I pulled down the lower dash today and found a plug with nothing to go to, orange wires in picture. Then another set of wires, that does not look factory, or could be, that is with the red/black wire cut. It runs...

Thank you!!

Greatly thank you!!!

Going to start on the ABS light that has been on since I bought the truck, 1993 LWB. Should I do the relay before I start anything else or is there a way to pull any type of code through this system? I have already inspected all abs sensor wiring underneath and all is good there. Brake pump...

It never ends. Your right. Just keep appreciating the fact it get better.

I have done about 5 classics over the past 23 years. I dig them. It is getting harder and harder as the years go by. The P38 always scared me as anytime there is a model change year it is just silly all over issues. This one even with. Few rust fixes is on point 100% original.

Greeting have not been on here much this summer, but got a ton done on our LWB. I questioned was it worth it when I bought. I could not deny the interior perfection and the 116k on the clock. Floor pans are perfect. The rust on one rocker, rear body mount and front under the headlights was the...

Selling my 1994 LWB. Great engine, trans. Interior is missing some pieces and there is no lower tailgate. Upper tailgate is rusted. Frame and chassis are rust free. Small rust hole at tailgate pan edge from leaking tailgate. The front floor has two very small holes from soaked pads as well. was...

Getting ready to part out my 1994 lwb. All body panels are zero rust as it was a Florida truck. Tailgate already sold. interior parts are hit and miss as it was not in great shape. frame is absolutely perfect. Engine is awesome 4.2 of course. 172k on the clock. Trans and transfer case all...

Which one or part number one fits the classic?

So been about 8 years since remodel of a RRC. I have a 1994 I am rebuilding. All is good, but the upper hose with the glorious sensor in the hose question. The hose on it now is a regular hose with no sensor threads. The sensor they have just setting on the engine. So factory looking. Is this...

Well we have been on the road all week now. Going in for the fuel filter recall , all good!!!

I used the timing sensor tool and the big crank pulley set up. I put the jackstand under it to transfer all the force onto the stand and reduce stress on the sensor tool. Worked very well to get a 4 ft pole on the wrench to really pull it well. I did not pull the starter.

Or……what I would do is give them to you and just pay shipping and when the next lad in this group needs them you ship them to him as long as they pay for shipping. make them a community tool set??

I have the crank pulley tool, the cam lock set and the injector slide hammer. The crank pulley tool, I cut the crank bolt threaded shaft so you do not have to remove the radiator, ;) The cam lock set I put regular bolts on the outside ends and removed the wing bolts that hit the shock towers. I...

Anyone have an OEM bumper guard for an lr4 they want to sell?

Yes first one, at 191k miles. Glad I made it that far, was starting to tick pretty good. It’s a good size job, attention to detail is a must and walk away when tired. Don’t try to push through it first time. If I did it again it would be much much easier now.