I have code P0455. I have replaced purge valve, gas cap, inspected all the lines, and smoke tested the system and can't find anything. Any ideas? I wouldn't care, but I have to pass emissions here in Atlanta.
They are on a D2, but will work just fine on a D1. Not sure on age, but I think they are 'older' RTE springs. Gray in color. No rust and seem to be very lightly used.
I have a complete setup from a parts truck. The springs are front RR 4-1 and rear RR 1-2. The shocks are typical OME shocks in good shape. $300 shipped.
Let me know what you need.
Parting out 2001 Disco. Engine runs, but the ECU and wire harnesses are no good.
Rear steel bumper (basically new)- SOLD
265/75r16 Nitto Ridge Grapplers (less than 100 miles on them) on Rover alloys - $1000
Interior is in good shape, if you need any bits make an...
I figured it out today. i performed some electrical wizardry after much studying in the RAVE manual. On connecter 4 (C0637) on the ECM i switch pin 12 to pin 14 and also switch pin 31 to pin 9. This got the correct signals to my fuel tank pressure sensor.
When I did the swap I kept all the...
I am getting p0452 (fuel tank pressure sensor) fault on my D2. I cannot for the life of me figure our why. I tried installing a spare fuel pump I have (sensor is built into pump) and still getting the code.
Nanocom reads as follows:
P0452
occurs during drive cylce c
signal too high
I can clear...
I spliced in a connector this morning and it worked! woohoo!
Now the last code I have is p0452. Fuel pressure switch related. Not sure what to do except replace fuel pump. Any ideas?
After reading through the RAVE it looks like I can splice in the supply from fuse #2 in the engine compartment fuse box and then use pin 30 (on the 52 pin ECU plug) for the second wire to the solenoid. Am I crazy? Or will this work?
I should add that i kept and currently using the 01 engine wire harness. It looks like the harness that included the CVS plug is on one of the body harnesses. It seems like I should be able to track the wires and just splice in a plug. The wires look to be pink and gray (I have a second D2 in my...
Long story short I did a body swap from an 01 to 03 disco after a rollover. Everything is done and the truck is running great. However... I have a small issue. The harness from the new body does not have a plug for the Canister Vent Solenoid (I assume because my engine and ecu are non-SAI and...
Hey everyone. My D2 is having a security issue. I have to hit the unlock on the fob every time i try and start the truck. If I don't I get the solid red security light and no crank. I have cleared all security codes and all unused PLIPS in the computer. What could be causing this?
Already replaced the crank position sensor. I have tried to use my iLand tool and my Autel tool and neither will communicate with the ECU. I can't even pull basic fault codes. However, both will communicate with the BCU....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.