Search results

Any clever repairs that are not vice grips for a broken T-handle on one before I order a new one and go through the install? It was very tough to pull anyway so I am probably due.

See my ad for this vehicle. denver.craigslist.org/cto/d/littleton-2000-land-rover-range-rover/6916074121.html Cheers

This is my ad, it has all of the details in it. denver.craigslist.org/cto/d/littleton-2000-land-rover-range-rover/6915890308.html Cheers

Anyone got a fix for the broken side marker light issue. They usually break, no matter how careful I am, when I need to change a bulb. The little plastic tab is undersized and gets brittle with age and heat. Tape, adhesive and new are lower on the list.

I have a 4.6 GEMS from a RR currently in my 96 Discovery, any issues putting that into an early 99 Discovery? Any computer issues? The evap system will be different, will that just plug in as needed?

Might be worth a look https://denver.craigslist.org/cto/d/aurora-1996-land-rover-discovery/6850462890.html

Going out of business and selling off rights to products. https://superwinch.com/ Attack of the Clones

Put the key in the ignition, turn it to start, wait 3 seconds while holding it there, and it starts, no problems, every time. Signs of a failing ignition switch? I read a bunch of the older ignition switch issues and this one seemed a little different. I do understand my options now though...

Anyone have a source for the Jag engine mounts that is not ebay for a 96 Disco?

Once again I go to use an air hose I have not used in several months and I find the fitting leaking. This seem to happen a lot to me. I go out and buy a bunch of fittings and swap them out and then a year or two later, things are leaking. Am I expecting too much or are they actually lasting...

Does anyone know if DII door cards will fit in a D1? They look close from pictures and I could move the speaker. I have not measured them. I can take a look next time at the salvage yard.

Clear ones for the old school 3000 series.

Q: How many FBI agents does it take to put a tarp over a van for transport? A: We don't know, it has not been done successfully yet.

So after drying out from a swim in the river, I found some really bad rust spots, holes really. Below both A pillars, outside below the B pillars not quite so bad, and the wheel wells below the C pillars less than both other spots. All pretty typical from what I have read. I did not think...

Are spacers used just because they are cheaper and easier to find than the correct length and rate of springs? Any advantage v disadvantage for them. Does it affect the overall goal, height of lift, performance of the spring, travel etc.?

Does anyone recognize these markings? Are they standard or HD axles?

These might be unicorns now for a 96 Disco, let me know if you have any. Down to my last few mods... HD rear axles and drive flanges 4.10ish gear set Mantec snorkle

I have been putting this off for years. PO had a very funky setup for the aux lights, 4 on the rack, work light out back, and two on the bumper. Had switches everywhere but they were integrated and mostly hidden. The 2 circuits I am having issues with are the ones he used heated seat switches...

Was turning a sharp corner in a parking lot and heard a clicking sound from the front end that went away as I straightened out. Then about 8 miles later, went around a corner and the vehicle stopped all forward motion with a spinning ringing sound coming from underneath. Did the same in all...

The white Disco with the 2.8 in it, Indiana plates. I would love to hear about the build. https://www.facebook.com/ianfrombigtiregarage/videos/1010645195751688/