04 Disco 2 help.

[boulder4x4]

So here is the deal.


I did the shuttle valve bypass and life was good for about 6 months. Then we had a rain storm and while driving home from a friends house the Amigos light up with the brake light this time. I had them read and it was the right front wheel sensor. It had been chafed from the tire so I replaced it. Lights are still on. I have also replaced:


frt pads and rotors
ABS module.
new shuttle valve by pass again
brake flush
and new front sensors




when I start the rover all the light s go off except the ABS. witch in turn turns on the amigos again... what did I miss?
Will the codes clear or do I need to clear them?

 

[disco_drum]

You will have to clear the codes. The amigos won't go away by just replacing the parts.

 

[boulder4x4]

roger that.. ill try that tomorrow.

 

[squirt]

Clear the ABS codes and see if anything comes back. It won't clear itself.

 

[German Gruner]

In order to get ABS light turned off, your Disco must move, and all wheel speed sensors compared. After this could be your light goes off. Did your Disco run a couple of meters?

Regards

 

[rovercanus]

In order to get ABS light turned off, your Disco must move, and all wheel speed sensors compared. After this could be your light goes off. Did your Disco run a couple of meters?

Regards

Not all codes will clear doing this, some must be manually reset.

 

[German Gruner]

Right, not all, but if no error, still he needs to move. I just wanted to clarify that :bigok:

Regards