'97 D1 Anti Lock light

lordhelemt

Well-known member
Dec 18, 2010
116
9
Trying to fix the anti lock light on a 97 D1. Ran the blink code and it show 3-1 (open circuit to the solenoid).

Hawkeye is showing fault 30 Inlet Valve Right Hand Front Power amp electrical connection interrupted and Fault 36 Inlet Valve Left-hand Rear Power amp electrical connection interrupted).

I don't know abs systems so i'm looking for a little help on where/what I should start checking?

Obviously the fuses need to be checked. Does anyone know the location of the abs relays? They are not in my Rave manual.
 
Last edited:

robertf

Well-known member
Jan 22, 2006
4,781
356
-
ABS relays are in the drop down relay bracket. it is in the copy I have.
 

Attachments

  • Screenshot from 2019-07-31 19-26-22.png
    Screenshot from 2019-07-31 19-26-22.png
    141.6 KB · Views: 23

lordhelemt

Well-known member
Dec 18, 2010
116
9
Here is where am at.

Fuse is good and is giving power to the relay. Tested the relay and it is switching power.

Tested continuity from the pump back to the wiring plug on the ECU. No breaks

Found the pin out for the pump. Check the ohms and the 8 solenoid pins and they in range. Checked the ground wires and they look good.

This leads me to believe the problem is with the ECU. Does anyone know how to check it? It doesn't look like it fails often so I just wanted to see if there was anything else I should check before getting one.
 

lordhelemt

Well-known member
Dec 18, 2010
116
9
It must have been a loose wire. Checked all the connections 1 last time, buttoned her up, cleared the codes and lights are off. Strangely enough the SRS light turned off as well.