Problem was fuel injectors not fully seated after new head gaskets.
99 D2, Just finished head gaskets, and am getting a Too Lean codes bank 1,2.
I used the Rave torque specs for every bolt
I’m thinking I need to check to see if I have all the fuel injectors are fully seated; there is no fuel smell, leak present
what else can before removing the upper air plenum/intake?
my codes are:
P1590 not found
P0130 O2 Sensor circuit Bank 1
P0174, too lean Bank 2
P0171 too lean Bank 1
tightened the gas cap, not it.
99 D2, Just finished head gaskets, and am getting a Too Lean codes bank 1,2.
I used the Rave torque specs for every bolt
I’m thinking I need to check to see if I have all the fuel injectors are fully seated; there is no fuel smell, leak present
what else can before removing the upper air plenum/intake?
my codes are:
P1590 not found
P0130 O2 Sensor circuit Bank 1
P0174, too lean Bank 2
P0171 too lean Bank 1
tightened the gas cap, not it.
Last edited: