SD roof rack for DII dementions?

[flyfisher11]

Will some good soul give me the dementions on their SD Highlander II roof rack for DII? I just need the outside dementions mainly eg. width and length along with individual length of each of the three sections, front section, middle angled section, and aft section. Any and all measurements will be greatly appreciated. I am comparing exact size with NWPs rack.

Cheers,

Mike

 

[flyfisher11]

I know someone has a Safety Devices Highlander II out there along with a tape measure. I really would appreciate these measurements.

Thanks,

Mike

 

[bshinn]

Mike,

Just got mine, give me a day or two & I'll get them to you. BTW mine's the low version, but I think the're the same.

Bob

 

[flyfisher11]

Thanks Bob! Yes they are the same except for height. I look forward to hearing back from you.

 

[bshinn]

Mike,

Width: front to rear is 48", with the exception of the front corners. All the tubing supporting the upper rail is welded on the lateral bars (ones used to mount to the raingutters) outside the lower perimeter tube, except @ the front corners & along the front & rear where it's welded directaly to the top of the tubing, so if you're planning on flooring you'll need to notch it there.

Length of the sectons: Front 28" ramp 8" & rear 50 1/2"

Hope this helps

Bob