S
Snwbord24
Guest
I recently removed my sway bars for more articulation offroad. I have a 2003 DII with 2" OME lift (779 front, 781 rear). I went out wheeling yesterday and had some problems. It seems the wheels are stuffing too far into the wheel well. I was going through a small area to check my articulation and had the front passenger and rear drivers side wheels stuffed pretty good and the other two were dropping down. I was amazed at how much because the last time I did this part I was getting wheels off the ground but not yesterday. While at this point I got stuck. The wheels that were dropping were spinning but the ETC wasn't switching power to the stuffed wheels. The light was on but I wasn't moving. I think I'm getting too much stuffage and the wheels are locked in the well. Is this a possibility? On some other areas after that I checked out the ETC and it was working fine.
I guess my options are putting the sway bars back on (don't want to do that), getting 1" spacers for a little more lift (which I want to do anyway), or getting longer bumpstops. Opinions? Will adding 1" of lift cure this or do I have to lengthen the bumpstops?
I guess my options are putting the sway bars back on (don't want to do that), getting 1" spacers for a little more lift (which I want to do anyway), or getting longer bumpstops. Opinions? Will adding 1" of lift cure this or do I have to lengthen the bumpstops?