Wondering if anyone can provide some insight. I have a 98 Disco. The TPS sensor was testing bad With the multi-meter so I ordered a new OEM replacement. I’m not a mechanic but I’m pretty good at replacing parts. TPS looks pretty simple. Unplug electrical connector, remove 2 screws, pull old sensor, replace in reverse. However the new sensor has the car idling at about 1800 RPMs. Am I missing a step? It fit just fine and looking at the two sensors the little plastic pieces that allow the sensor to move based on the throttle shaft seem to be in the same alignment so that doesn’t seem to be the issue. As far as I can tell there is no idle adjustments. Any help would be appreciated.