| Author | Message | ||
     clint lupton (Clint_lupton) New Member Username: Clint_lupton Post Number: 3 Registered: 03-2004 |
Factory engine heads from a 2000 D2 4.0L with only 10k miles. Stripped from a motor with a blown bottom end. Complete with valves and springs. No gaskets or head bolts. ( you shouldn't re use them anyway ) casting number HRC 2479 15 These are $900 each new!!!! First $400 plus shipping takes em both. Thanks, Clint Grand Rapids, MI     | ||
| clint lupton (Clint_lupton) New Member Username: Clint_lupton Post Number: 6 Registered: 03-2004 |
This is like a reverse auction. :-) Anybody for $300... | ||
| Wicks (Wicks) Member Username: Wicks Post Number: 161 Registered: 03-2003 |
Question is if I bolt em onto my 97 D90 4.0, will I get more power? | ||
| Todd Phenneger (Toddp) Member Username: Toddp Post Number: 198 Registered: 10-2002 |
I doubt it. But you could use them as spares. Port and Polish them, Get new guides and seals put in it when your done and then you have nice high flow heads to swap onto your rig later and that should yield a little passing power. Esp if coupled with a cam and chip. At least thats what I'm thinking but It's not int he budget for me this month. Or else I'd be bidding on them. :-( l8r Todd | ||
| clint lupton (Clint_lupton) New Member Username: Clint_lupton Post Number: 9 Registered: 03-2004 |
Heads are still available. Ready to Port and Polish! FYI The original motor spun a bearing and the whole engine was replaced under warranty with only 10k. The heads were inspected by a LR tech and were found to be in fine condition, so they were removed. |
