| Author |
Message |
    
Dave_Lucas (Dave_Lucas)
| | Posted on Thursday, October 24, 2002 - 10:37 pm: | 
|
Kyle,
I have seen it mentioned on here that you are using a Hobart Ironman welder, In one post you mentioned that you had the ability to add a tig torch to it.
What model are you using and what was involved with adding the tig setup to it?
I am currently looking at the Millermatic 175, 210 or possibly the Hobart 210. I wish I could afford one of the high end setups like we had where I used to work, but I can not justify spending that kind of cash for what I will use it for. I am better with tig than stick or mig so I would like to be able to add the tig, but in reality most of what I will be doing will be mig.
Thanks, |
|
Closed: New threads not accepted on this page