| Author | Message | ||
     Nick A. (Nick) New Member Username: Nick Post Number: 12 Registered: 03-2003 |
I know there is a post or two on this but I am being lazy. Stock disco 1 want to go from rotoflex shaft to u-joint who sells these kits.I remember one outfit wood something or another , anyway it is a stock vehicle. | ||
| Richard Dekkard (Richard_dekkard) Member Username: Richard_dekkard Post Number: 48 Registered: 04-2003 |
http://www.4xshaft.com/ Tom Woods | ||
| Nick A. (Nick) New Member Username: Nick Post Number: 13 Registered: 03-2003 |
Called Woods driveshaft co. customer service very helpful. They need the measurement from transfer case flange to diff flange to build a shaft would anyone have that info. It is a stock 96 D1. Has anyone used their products and were you satisfied?, thanks... | ||
| Greg Davis (Gregdavis) Senior Member Username: Gregdavis Post Number: 853 Registered: 08-2002 |
Bill at GreatBasinRovers.com also sells this conversion kit. His specialty is Rovers so he wouldn't need any measurements. | ||
| Rob Davison (Nosivad_bor) Senior Member Username: Nosivad_bor Post Number: 305 Registered: 02-2003 |
nick atlantic british has the kit for $350 http://www.atlanticbritish.com/ProductList.asp?Category=ALL&Vehicle=D1&PerPage=1 &ListType=DETAIL&PartNumber=9300 | ||
| Brent Fox (Bfox) Member Username: Bfox Post Number: 58 Registered: 10-2002 |
There is one on ebay for $150. | ||
| Jesse Lessard (Jlessard) Member Username: Jlessard Post Number: 47 Registered: 10-2002 |
i recently did my roto-to-ujoint conversion for a 96 D1. Got it from Bill at GBR, really nice guy, he was quite helpfull with a couple questions i had while doing the work. Cost about $300 just be warry of that damned center peg thing... |
