| Author | Message | ||
     Cardboardkiller (Cardboardkiller) New Member Username: Cardboardkiller Post Number: 12 Registered: 05-2003 |
Anyone have a source for custom brake pipe? | ||
| A. Ali (Alia176) Member Username: Alia176 Post Number: 57 Registered: 03-2003 |
Once we got lucky and found the right size at a Carquest (out of desperation). So that tells me that the size isn't too unusual but the unfortunate part is that you'll need to bend it and make up your own ends. I bought a small length from LR and it came as a straight piece which I bent for my application. The tool to make the ends are common and inexpensive. Now if you're talking about extended brake hoses then there are several vendors: Rovertym, Paragon, etc. | ||
| Cardboardkiller (Cardboardkiller) New Member Username: Cardboardkiller Post Number: 13 Registered: 05-2003 |
What is the proper way to measure the pipe and connectors so I get the right stuff? | ||
| Bill Bettridge (Billb) Senior Member Username: Billb Post Number: 783 Registered: 02-2002 |
thread size should be 10 x 1 mm - assuming 88 and on MY. Bill | ||
| Cardboardkiller (Cardboardkiller) New Member Username: Cardboardkiller Post Number: 14 Registered: 05-2003 |
I've got a 93 LWB that I am pulling the ABS system off of and putting a Girling MC and Servo on. I would imagine that they are all the same. Thanks. | ||
| Cardboardkiller (Cardboardkiller) New Member Username: Cardboardkiller Post Number: 15 Registered: 05-2003 |
Can anyone tell me what flare the ends for the lines coming off the master cylinder have for a Girling MC? I don't want to pull a line off until I have all the parts, so I can put it back together without having it down for a week. Thanks. |
