| Author | Message | ||
     Bill Butt (Azbutter) New Member Username: Azbutter Post Number: 9 Registered: 06-2003 |
I checked archves but can't find anything - I know I saw it somewhere. Does anyone know if you can install the rear jump seats on a Disco if they are not equipped from the factory as such? The dealer told me no but I don't beleive them... | ||
| Gil Stevens (Gil) Senior Member Username: Gil Post Number: 326 Registered: 02-2002 |
it would be very difficult, as im not sure how you would get the seat locks into the floor. the dealer was not lying, but with a little fabrication im sure you could do it. | ||
| Chris Browne (Chris_browne) Member Username: Chris_browne Post Number: 147 Registered: 02-2003 |
Its been talked about and the dealer is telling the truth. | ||
| Bill Butt (Azbutter) New Member Username: Azbutter Post Number: 10 Registered: 06-2003 |
Oh yeah, forgot about the floor!! | ||
| Brian Goodner (Bluewater) New Member Username: Bluewater Post Number: 6 Registered: 03-2003 |
it's not worth the time. | ||
| Greg Davis (Gregdavis) Senior Member Username: Gregdavis Post Number: 875 Registered: 08-2002 |
Well, I've looked in the back of a stripped DII (rollover) and it appeared that all of the mounting locations, etc were there. Only thing you'd have to do is swap all of the parts over. I even seem to remember that the floor was ready to accept the latches, etc. Just find a donor vehicle and swap everything over at once. | ||
| Bill Butt (Azbutter) New Member Username: Azbutter Post Number: 11 Registered: 06-2003 |
Excellent...thanks, Greg. | ||
| Eric B. (Ebbnyc) New Member Username: Ebbnyc Post Number: 8 Registered: 05-2003 |
I looked into this as well. There's an after-market bench thay can bolt to the floor, but the bucket seats are a no-go. Also, something I was told by a few people and never thought about was that any of those seats (stock or other) make a ton of noise (rattle) |
