Need help with an antenna install (ge...

Log Out | Topics | Search Moderators | Register | Edit Profile

Author Message   Richard Grayson III (Skaramunga) New Member Username: Skaramunga Post Number: 5 Registered: 02-2003 Posted on Wednesday, August 27, 2003 - 02:02 pm:    i just need a starting point, through glove box? under?   Mark Devereux (Groupw) Member Username: Groupw Post Number: 88 Registered: 12-2002 Posted on Wednesday, August 27, 2003 - 02:15 pm:    Radio antenna right? Pull the glove box, pull the right quarter panel, pull the windshied wash reservoir. Now its easy. Replace your antenna and put everything back together. Oh yeah. I think you have to unbolt the right side of your front bumper to get the quarter panel off.   Brian Dickens (Bri) Senior Member Username: Bri Post Number: 600 Registered: 08-2002 Posted on Wednesday, August 27, 2003 - 02:27 pm:    If you are small enough and limber enough just remove the inner wheel well plastic cover. You will then see the antenna. Remove the panel beneath the glove box. Have a second person in there while you carefully tug on the antenna wire. You should be able to determine which one it is under the glove box. Disconnect it where it can be disconnected and pull it through. Buy a $15 replacement from pepboys, feed the wire through and install in the fender. Removing the fender and washer resevoir is not necessarily needed. Do a search and find all the other posts on the topic.   Porter Mann (Porter) New Member Username: Porter Post Number: 37 Registered: 05-2003 Posted on Wednesday, August 27, 2003 - 04:18 pm:    I did the same thing, I removed the inner wheel well pastic cover to get to the cable. I disconnected the cable from behind the glove box and gently pulled it through the hole from the inner fender well. To remove the little grommets, use a thin flathead to pop to top of the grommets off from the base, and then the larger portion just pulls out.