| Author | Message | ||
     Jason Bradley (Jason_bradley) New Member Username: Jason_bradley Post Number: 3 Registered: 02-2003 |
I submerged my 1990 rover/ecu. 3 weeks later, all fluids are changed, distributor is nice and dry, no water got in the engine. It starts immediately but is running on half an engine and will only stay running if I keep my foot on the gas.. code says 03.. I can't find 03 listed anywhere. | ||
| patrick findlay (Montreal) New Member Username: Montreal Post Number: 26 Registered: 06-2003 |
SAME THING HAPPENED TO ME.i THEN TOOK OUT THE ECU AND TOOK IT APART.IT ONLY HAS A COUPLES OF SCREWS AND THE CIRCUIT BOARD IS ON THE TOP,SO WHEN YOU TAKE IT APART CLEAN THE BOTTOM PLATE REAL GOOD AND DRY OU THE CIRCUIT BOARD WITH AN HAIR DRYER OR LET IT SIT FOR A COUPLES OF HOURS AND THE HUMIDITY SHOULD DRY OUT.I ALSO CHANGED THE FUEL FILTER AND EMPTIED THE GAS TANK BECAUSE I HAD WATER IN IT AND THAT GAVE ME SOME PROBLEMS.iF YOUR LUCKY AFTER THAT IT MIGHT RUN JUST FINE LIKE MINE DOES.GOOD LUCK! |
