| Author | Message | ||
     Greg Davis (Gregdavis) Senior Member Username: Gregdavis Post Number: 1005 Registered: 08-2002 |
Well, I couldn't find what I wanted, so I made my own this weekend. It's based off of the SouthDown rear design, but it won't fit a front axle because of the tie rod and because the pinion is offset to the other side. Basically I made a template from my rear unit, and then made a different front "snout" for it. Because it is not my own design (based off of S-Down's), I will not duplicate nor sell these. Just wanted to make that clear.     | ||
| Chris von C. (Chrisvonc) Dweb Lounge Member Username: Chrisvonc Post Number: 259 Registered: 07-2002 |
I like that! | ||
| Blue (Blue) Dweb Lounge Member Username: Blue Post Number: 485 Registered: 04-2003 |
yeah, nice tie rod protection & pinion slider | ||
| Bill Bettridge (Billb) Dweb Lounge Member Username: Billb Post Number: 1073 Registered: 02-2002 |
Looks good - impressive Fab work! | ||
| Greg Davis (Gregdavis) Senior Member Username: Gregdavis Post Number: 1007 Registered: 08-2002 |
Thanks for the compliments. Oh, those tabs are for my steering stabilizer. I moved it behind the front axle between the housing and the tie rod. | ||
| Chris von C. (Chrisvonc) Dweb Lounge Member Username: Chrisvonc Post Number: 260 Registered: 07-2002 |
I know its hard to get one but any full side shots of it? CVC | ||
| Greg Davis (Gregdavis) Senior Member Username: Gregdavis Post Number: 1010 Registered: 08-2002 |
I'll try, but it's hard to get it to show up because I can't get much light under there. Lemme see what I can do. | ||
| Rick Cordova (Imx) Member Username: Imx Post Number: 56 Registered: 08-2002 |
Greg, Very nice if you ever do make more let me know I could use one. Very nice weldding. Rick |
