Author |
Message |
   
martyn evans (Evansash)
New Member Username: Evansash
Post Number: 6 Registered: 12-2002
| Posted on Wednesday, October 15, 2003 - 05:09 pm: |
|
Is there a knack to removing the time clock to change the bulb as I do not want to damage anything? |
   
Bazzle (Bazzle)
New Member Username: Bazzle
Post Number: 35 Registered: 09-2003
| Posted on Wednesday, October 15, 2003 - 05:39 pm: |
|
I asked this recently. Slde a putty knife in top and pull out a bit, repeat for bottom until it comes out. bazzle |
   
Dean Brown (Deanbrown3d)
Senior Member Username: Deanbrown3d
Post Number: 896 Registered: 02-2002
| Posted on Wednesday, October 15, 2003 - 06:12 pm: |
|
Is it really necessary to state the 'time' clock? On the D2 it just pops out. |
   
Roger M (Ciscowiz)
Member Username: Ciscowiz
Post Number: 88 Registered: 02-2003
| Posted on Saturday, October 18, 2003 - 05:23 am: |
|
You can go the el cheapo route and just solder in a new W1 bulb into the bulb holder. A pair cost me 70 cents at Autozone. The bulb and holder run about $8 at the dealer. |