| Author | Message | ||
     Jess Brandt (Disco285) Member Username: Disco285 Post Number: 131 Registered: 09-2002 |
i know everybody is goign to say search the board. but my question regards if i cna get a meineke guy to route it to a precut hole in the fender. cuz i want to have my magnaflow from my old disco put on my '96... if i cut the hole in the fender could he run it there? thanx in advance, jess | ||
| Pascal Van Strydonck (Vertige) New Member Username: Vertige Post Number: 27 Registered: 10-2003 |
I have been curious about that to. What is neended for relocating the pipe thru the rear quarter panel?? | ||
| Joey (Joey4420) Senior Member Username: Joey4420 Post Number: 364 Registered: 04-2003 |
As long as the person doing the work is a good pipe bender and has a Mig welder he should be able to do the work that you want done. If not, you need to find someone who can. Of course I wouldn't go to Meineke only because I am cheap  | ||
| Jess Brandt (Disco285) Member Username: Disco285 Post Number: 133 Registered: 09-2002 |
who would u go to? a local place or something? i am cheap too... | ||
| Joey (Joey4420) Senior Member Username: Joey4420 Post Number: 367 Registered: 04-2003 |
I would either drive to a few local muffler shops, or call them and get a quote. When you go to any Chain Store, the price usually is higher. | ||
| Chris Browne (Chris_browne) Senior Member Username: Chris_browne Post Number: 424 Registered: 02-2003 |
One thought, if you can don't route the last few inches of the pipe upwards-if water ingestion happens it gets alot more difficult to clear out the exhaust | ||
| Greg French (Gregfrench) Senior Member Username: Gregfrench Post Number: 643 Registered: 11-2002 |
Check Greg Davis's pictures. |
