| Author | Message | ||
     mark peterson (Mspeters) New Member Username: Mspeters Post Number: 12 Registered: 07-2003 |
Anyone every seen any production versions of these ? They were affiliated with Scorpion UK my Rovertym arms lack the width clearance to run sway bar, with teh production tolerance with my bar. http://www.equipe4x4.com/preparazioni%20speciali.html  | ||
| Will Cupp (W_cupp) Member Username: W_cupp Post Number: 243 Registered: 07-2003 |
Sway Bar? People still use those? | ||
| Greg Davis (Gregdavis) Senior Member Username: Gregdavis Post Number: 1101 Registered: 08-2002 |
Those don't look forged to me. You can see welds around the circumfrence of the bushing mounts. Plus, that's a very intricate design to forge and there are no forge marks. I think they were fabricated from stock. They do look nice though!  | ||
| Shawn McKenzie (Shawn) Member Username: Shawn Post Number: 158 Registered: 10-2002 |
There are some pretty sweet looking goodies on that site. Can anyone here read Italian? Wondering if they mention a North American distributor? | ||
| Phillip Perkinson (Rover4x4) Senior Member Username: Rover4x4 Post Number: 596 Registered: 02-2003 |
Its the same as the scorpion racing stuff. | ||
| Sergei Rodionov (Uzbad) Member Username: Uzbad Post Number: 234 Registered: 08-2003 |
Shawn - babelfish.altavista.com is your friend | ||
| Tarek Khalil (Pharaohdisco) New Member Username: Pharaohdisco Post Number: 6 Registered: 12-2003 |
I have RoverTym front radius arms installed and I am running with my front anti sway bar. You will need to install a 8 cm spacer below the anti sway bar brackets. | ||
| mark peterson (Mspeters) New Member Username: Mspeters Post Number: 13 Registered: 07-2003 |
At least in my case, 97 D1, sway bar drop down brackets to clear the driveshaft, etc, won't cut it. The ball-jointed ends of the sway bar collide, barely, with the now fatter radius arms. |
