| Author | Message | ||
     Jeff Gallo (Jeffgallo) New Member Username: Jeffgallo Post Number: 10 Registered: 01-2004 |
How difficult is it to replace the SLS air bags with springs? I am shopping for a used Disco and plan on lifting whichever one I buy. Should I avoid Disco's with SLS? | ||
| Rick Neff (Lostinboston) Senior Member Username: Lostinboston Post Number: 271 Registered: 06-2003 |
I like my SLS and have a 3" lift. Many people here hate it. Check the valves occaisionaly andyou shouldnt have a problem with leaking. as far as swapping, all you need are spring perchs and springs. AB is also selling an airlift suspension, which is basically sls but it goes inside the springs. -Rick | ||
| Al Cruz (Alc) Member Username: Alc Post Number: 95 Registered: 10-2002 |
I coverted my SLS on my rig, had way too many issues with it deflating. Besides springs perches you will also need the isolators. And I believe EE now carries those isolators. And if your going for a 3" lift don't forget to get 1" spacers. Oh and it's very easy, it'll take you about 4 hours for the conversion. It helps to have two floor jacks and a spring compressor. Al | ||
| Chris Browne (Chris_browne) Senior Member Username: Chris_browne Post Number: 601 Registered: 02-2003 |
The ABP set up is load assist not SLS, | ||
| Clay W Davis (Cwdavis4) Member Username: Cwdavis4 Post Number: 45 Registered: 09-2003 |
So I was getting ready to add a 2” lift to my ’03 Disco by adding the rovertym spacers in the rear (I have SLS). Do I need to worry about the rear airbags deflating? I’ll be honest I’m not sure how these spacers work with the SLS but I’m didn’t think the spacers were ‘fooling’ the SLS bags to fully inflate (I believe that is the other method to achieve the rear lift with SLS). Thank you for any insight. |
