Codes again... still Log Out | Topics | Search
Moderators | Register | Edit Profile

DiscoWeb Bulletin Board » Message Archives » 2004 Archives - Discovery Technical » Archive through March 02, 2004 » Codes again... still « Previous Next »

Author Message
 

gordon sitts (Gsitts)
Member
Username: Gsitts

Post Number: 81
Registered: 10-2002
Posted on Sunday, February 22, 2004 - 09:56 pm:   Edit Post Delete Post Print Post

Code 1
I get p1193( oxygen sensor heater circuit open downstream) if I get hung up in traffic or when I let it idle for a long time. I replaced the front 02 sensors but can detect no difference.
The truck runs great and gets the same mileage it usually does. Does anyone have any ideas what to look for?
Code 2
I get 1317 (ABS rough road line low fault)at regular intervals no mater what I'm doing. Any ideas there?
Thanks
Gordon
 

gordon sitts (Gsitts)
Member
Username: Gsitts

Post Number: 82
Registered: 10-2002
Posted on Tuesday, February 24, 2004 - 04:59 pm:   Edit Post Delete Post Print Post

I'm still hoping some good hearted LR tech can give me a steer
Please!!!
Gordon
 

Joe B (Denverrover)
Member
Username: Denverrover

Post Number: 159
Registered: 02-2003
Posted on Tuesday, February 24, 2004 - 06:49 pm:   Edit Post Delete Post Print Post

I heard that valve issues can cause the o2 sensor code. Anyone else have any input?

JB
 

Brad Noviski (Bradnoviski)
Member
Username: Bradnoviski

Post Number: 104
Registered: 02-2003
Posted on Tuesday, February 24, 2004 - 07:06 pm:   Edit Post Delete Post Print Post

gordon

The code is for downstream, which I beleive this is after the cats. I had the same code on y 96 D1. It is also known as bank 2 (I think). If I am wrong, somebody please correct me. So if you replaced the front ones you may have replaced the wrong one.
 

gordon sitts (Gsitts)
Member
Username: Gsitts

Post Number: 83
Registered: 10-2002
Posted on Wednesday, February 25, 2004 - 06:42 pm:   Edit Post Delete Post Print Post

I did the sensor change for other reasons it just happened to occur in the middle of this codes mess. I just didn't see any changes in the codes but you might be right about it being part of the problem. Does anyone know which code is connected to which sensor that might help
Thanks
G

Topics | Last Day | Last Week | Tree View | Search | User List | Help/Instructions | Program Credits Administration