| Author | Message | ||
     Ethan Makarowski (Ethan) Member Username: Ethan Post Number: 43 Registered: 04-2003 |
It's getting time to install my 3" lift to my '94 D1. The vehicle has 148K with the associated rotoflex wear. There are currently no vibes with the stock set-up but I want to be prepared if any vibrations appear after the lift. I want to replace the rotoflex with a U-jointed driveshaft from my usual parts source for my series rover... Paddocks Spares, in the UK. I just wanted to double check the parts #'s so I order the right one. Can anybody provide the right part # for the shaft that I would need. The Paddock's # is FRC8387 (Rear Propshaft - V8 from VA541628). Just want to double check... THANKS for the help. Regards, Ethan Makarowski ewmakaro@hotmail.com | ||
| Tarek Khalil (Pharaohdisco) Member Username: Pharaohdisco Post Number: 43 Registered: 12-2003 |
I used a custom made driveshaft built by Tom Woods in the US. If you are in the UK check Scorpion Racing. They have rear double cardan U-jointed driveshafts for Discoveries. The 4 bolt drive flange which you will need will be part no. STC4858. | ||
| Mike Rupp (Mike_rupp) Senior Member Username: Mike_rupp Post Number: 344 Registered: 02-2002 |
For a 3" lift you shouldn't need a double cardan driveshaft for the rear. A standard ujointed drive shaft should work fine. There is a write up in the tech section that gives all of the details. |
