Author |
Message |
   
ian taylor (Iantaylor)
New Member Username: Iantaylor
Post Number: 2 Registered: 04-2004
| Posted on Thursday, April 15, 2004 - 07:19 pm: |
|
I have a 1992 three door, and the passenger seat frame has just cracked. One of the two U shaped channels under the seat cracked at the bend and separated from the weld onto the horizontal cross member that runs along the back of the seat. It looks like the U shaped channel is the wrong way around, with the web in tension rather than compression ( LR engineering hey ? ) I basically just intend to remove the seat, weld this piece back on, then re-install. Anyone had any similar problems with a three door or D1 ? Apparently the D1 3 door seat is the same as the Rangie's ? |
   
Shaun Power (Shaunp)
Senior Member Username: Shaunp
Post Number: 285 Registered: 05-2003
| Posted on Friday, April 16, 2004 - 03:31 am: |
|
Common fault I just welded one up on a mates 2 door last week end. |
   
Lance Cowley (Duckhunter)
New Member Username: Duckhunter
Post Number: 38 Registered: 01-2004
| Posted on Friday, April 16, 2004 - 04:01 am: |
|
yes, throw a weld on it and put it back in better then new |
   
Wizard (Wizard)
Member Username: Wizard
Post Number: 68 Registered: 11-2003
| Posted on Friday, April 16, 2004 - 04:17 am: |
|
Hi Ian This is another common fault with the 3 door Disco,If you weld it, it will only crack again. Best thing to do is replace the U shaped channel with a section of thick flat bar 6mm x 30mm is perfect. Cheers wizard |