| Author | Message | ||
     Jason Smith (Smithers) New Member Username: Smithers Post Number: 11 Registered: 11-2003 |
I have a 97 RR 4.0 with a bad front hub bearing. The bearings are not replaceable. You must replace the "bearing assembly". My problem is I can not figure out how to remove this assembly? I have removed the wheel, the caliper, and the rotor. I also removed the 32mm nut in the center of the rotor. I removed the four bolts that apear to hold the bearing assembly in place, from the rear. Now I'm stuck? Nothing else wants to come off. Please help me out. Thank You Jason | ||
| Jason Smith (Smithers) New Member Username: Smithers Post Number: 12 Registered: 11-2003 |
Could somebody look in the service book. | ||
| Alan Bates (Alanb) Senior Member Username: Alanb Post Number: 461 Registered: 07-2002 |
From what you described and looking at the service manual, it should just then slide right off. I can fax you the pages if you want, e-mail me a fax number off-line. | ||
| Pugsly (Pugsly) Senior Member Username: Pugsly Post Number: 283 Registered: 11-2002 |
Jason - you might want to use a slightly more helptful / descriptive subject. A lot of folks will scan the message subjects to see if it concerns something they have knowledge on. | ||
| Jason Smith (Smithers) New Member Username: Smithers Post Number: 13 Registered: 11-2003 |
Thanks Alan, I did get it out. I had to use a sledge hammer. It was very tight. | ||
| Ron Beckett (Ron_beckett) New Member Username: Ron_beckett Post Number: 21 Registered: 01-2004 |
The bearing numbers are shown at Andy C the WB site www.p38a.co.uk - see the wheel bearing menu item or go to http://www.cunningham.me.uk/rangie/bearing.php Ron |
