DISCO WIRING FOR ELECTRIC

DiscoWeb Message Board: Archives - All topics: 2001 Archive - Technical Discussions: DISCO WIRING FOR ELECTRIC
  Subtopic Posts   Updated


Top of pagePrevious messageNext messageBottom of pageLink to this message   By will on Thursday, March 08, 2001 - 06:14 pm: Edit

I would like to wire my disco so I can run electrical appliances out of it and wondered if anyone had any suggestions on how to do this? I would like to run 2 outlets out of the rear but I want a clean job and not some dangling receptor.

Any advice is appreciated...

Will

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Mike on Thursday, March 08, 2001 - 08:35 pm: Edit

Have you thougth about adding an aftermarket power inverter instead? You can get up to 300 watts of electricity through your cigarette lighter. After that, you have to run dedicated (and big) wires from the battery to the converter. I don't recommend running 120 volts through your vehicle. I purchased a power inverter from Radio Shack for less than $90.00 and store it under my seat. I pull it out and plug it whenever I need 120 volts. It works great.

LoL,
Mike


Posting is currently disabled in this topic. Contact your discussion moderator for more information.

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation