By andrew on Friday, August 10, 2001 - 12:05 am: Edit

I have a two inch lift and have replaced the rear rubber donut three times in the last year and a half and just about to replace the next one if i buy a second hand shaft with cv and pinion drive flange is it easy to change over? From what year disco should i get one from?

Regards

Andrew
94 300tdi

By Ron on Friday, August 10, 2001 - 03:49 am: Edit

Any disco I or any RR with an lt230 so like 85-88

all the same length

Ron

By mike holland on Saturday, August 11, 2001 - 10:16 am: Edit

are you replscing the centering bushing at the same time?

By andrew on Saturday, August 11, 2001 - 01:38 pm: Edit

Yes, i have been replacing the bush always a pain to get out but get there in the end. Any ideas how easy or hard a new shaft would be to put on?

Regards

Andrew(Australia)
94 300tdi

By mike holland on Sunday, August 12, 2001 - 04:29 am: Edit

it is very easy all you need is the driveshaft the new pinion flange and the spacer that goes behind the pinion flange. (the pinion flange is shorter for the u-joint shaft)

By andrew on Sunday, August 12, 2001 - 01:17 pm: Edit

Thanks for your help Mike.

Regards

Andrew(Australia)