By nadim on Monday, August 13, 2001 - 01:26 pm: Edit

hello guys...hope all are fine and dandy...

PLEASE I NEED TO KNOW THE SPECIFICATIONS of the RD56 ball bearings to be used on the 3rd member...i was unable to use the stock ones...they were too narrow for the ARB housing...

I will go to sleep now and wake up in 6 hours to check on you guys...thanks...

By Perrone Ford on Monday, August 13, 2001 - 04:09 pm: Edit

When you wake up, call Bill at Great Basin Rovers. He'll likely know the answer off the top of his head.

Good luck,

-P

By nadim on Monday, August 13, 2001 - 08:48 pm: Edit

perrone...

i am in Lebanon, the middle east...so cannot get to call easily...

i'll try to do that anyways...

thanks...

nadim

By Ali on Tuesday, August 14, 2001 - 12:35 pm: Edit

Nadim,

If you have the stock bearings, is it not possible to check out the bearing p/n's that are stamped on them and then call around bearing houses? I don't know about Lebanon though! I replaced mine with Timken bearings that cross referenced with the ones I pulled out.

Just a thought. Try these parts houses:

Motion Industries
Applied Technologies

They usually ship UPS with a crdit card #. There are many in the US so just pick one as they're all connected together via Intranet.

Good luck.