By Chris Merritt (Smokinbro) on Monday, August 20, 2001 - 11:44 am: Edit

My two year old son recently 'modified' my '98 Disco. Somehow???? he managed to 'break' the factory fog light switch. I picked up a replacement switch and now I have to install it.

Can anybody tell me which bits I have to take off the console/dash to access the switch?

I am sure that there was a discussion going on here about it, however, I couldn't find it.

By dburress on Monday, August 20, 2001 - 02:40 pm: Edit

Just pull the complete bank of switches forward from the dash, then disconnect the switch from the harness, remove damaged switch from said bank, replace and then reverse the procedure.

By Chris Merritt (Smokinbro) on Tuesday, August 21, 2001 - 03:57 am: Edit

dburess - thanks, but i was looking for alittle more.

Like does the cup holder have to come out etc?

Essentially, what are the R&R instructions for the Fog Light Switch. (don't wanna break any plastic)

By Chris Merritt (Smokinbro) on Tuesday, August 21, 2001 - 03:57 am: Edit

dburess - thanks, but i was looking for alittle more.

Like does the cup holder have to come out etc?

Essentially, what are the R&R instructions for the Fog Light Switch. (don't wanna break any plastic)

By Leslie N. Bright (Leslie) on Tuesday, August 21, 2001 - 04:01 am: Edit

Chris,

dburress pegged it... that's as detailed as it gets. The switch cluster pulls out, no need to fiddle w/ the cup holder. Unplug/plug kind of job. One banana. 5 minutes, tops.

-L

By Chris Merritt (Smokinbro) on Tuesday, August 21, 2001 - 04:22 am: Edit

Then thanks to you both - I'll give it a shot

By Chris Merritt (Smokinbro) on Tuesday, August 21, 2001 - 06:06 am: Edit

Thanks again, just as you said, it pulls right out!. Now I have found another problem. apparently previous owner decided to chop off the factory connector.......now I have to fix that!