Subtopic | Posts | Updated |
By Abyl Sandow (Abyl) on Monday, September 17, 2001 - 01:17 pm: Edit |
I have '95 disco and it just started dying at an idle(stop sign or something). It starts fine and runs fine over 1000 RPM but under it won't hold an idle unless I release the pressure in fuel tank using the fuel cap. After that it will run fine. I am starting with the fuel ventilation but I am not familiar with it. Is there a good starting point and remedy other that ventilation?? Thanks alot
By Abyl Sandow (Abyl) on Monday, September 17, 2001 - 03:24 pm: Edit |
Lot of questions: lambda sensor and O2 sensor the same? Does code 44 mean I need a new sensor? Any cheap place to find one?
By Drew on Monday, September 17, 2001 - 06:29 pm: Edit |
Yes, for a 95 disco it is about time to replace the O2 sensors. I bought a pair very inexpensively from Nathan Crabtree.
By Abyl Sandow (Abyl) on Monday, September 17, 2001 - 07:16 pm: Edit |
Can someone give the heads up on nathan crabtree?? Where and how? Also it is easy to change the sensors?? Thanks
By Robert Mann (Oldscout) on Monday, September 17, 2001 - 07:44 pm: Edit |
You can reach Nathan at:
[email protected]
If you can change a spark pulg you can change a O2 sensor.
Posting is currently disabled in this topic. Contact your discussion moderator for more information. Administrator's Control Panel -- Board Moderators Only
Administer Page |
Delete Conversation |
Close Conversation |
Move Conversation