Subtopic | Posts | Updated |
By Dean Brown (Deanbrown3d) on Monday, October 01, 2001 - 04:29 am: Edit |
FYI Measurements for disco 2 jate ring enthusiasts:
The front frame (just behind the crush cans) of a disco2 is exactly 3 inches wide. With the LR brush bar, this spacing expands out to 4 inches exactly.
There is also a bar that runs directly down and across, below the radiator, and this bar attaches to the same place. Unfortunately this anchors with side-strengthened U-type bars, using up another half inch lip.
If anyone has put on jates with the brush bar and this other bar still attached, please give us a photo.
Dean
Posting is currently disabled in this topic. Contact your discussion moderator for more information. Administrator's Control Panel -- Board Moderators Only
Administer Page |
Delete Conversation |
Close Conversation |
Move Conversation