By Matt (Bigbassinbob) on Tuesday, October 09, 2001 - 02:39 pm: Edit

I just ordered an ARB non-airbag bumper for my 95 disco, and I know its not going to be easy to figure out how to install it. Is there anyone who could tell me where I could find a detailed write-up about the installation? Any help would be greatly appreciated. Thanks -Matt

By Brian K on Tuesday, October 09, 2001 - 03:10 pm: Edit

Really, it is super simple to install the ARB. After taking off the original bumper it will all become self-evident. But make sure to have a drill handy, as you MAY need to ream out the four front holes a bit to make way for the bigger bolts that are supplied.

And I think ARB's come with a simple diagram anyway.

By Jonny on Tuesday, October 09, 2001 - 08:24 pm: Edit

Just like Brian said it dead easy. Im 17 and i did it with no instructions (16 at the time).But ill help you out alittle bit.

*Undo all the spray jets and the hoses.(the jets for the headlights)
Theres 4 bolts holding the original bumper on. (2 on each side)

*Take them out.

*Pull bumper off

*Get two people to hold the new bumper up while you slot the bolts in. Bumper comes with another 2 bolts, making it 3 either side. Adjust bumper till it sits right on the car then tighten the bolts.

*Feed the hoses through the bumper and install jets and shes done.

Sorry no pics
Its easy dont stress

By [email protected] on Thursday, October 11, 2001 - 11:15 pm: Edit

putting on my ladder was harder than putting on my ARB :-)