By Petros Machlis (Runnerma) on Friday, October 26, 2001 - 08:43 am: Edit

My clutch has to push the lever all the way down to the floor to change gear.I have problem to engage 2nd gear at 4rpm and up. Is that normal?
How I can adjust it to demultiplex 1" upwards of the floor?

By Discosaurus (Discosaurus) on Friday, October 26, 2001 - 08:56 am: Edit

As far as I know, there is no true adjustment since the Disco has a hydraulic clutch. You need to bleed the air out of your system.

It is a simple job but will require two people unless you have a pressure bleeder. Bleed the system the same way you would bleed brakes. The bleed screw is on the slave cylinder attached to the bell housing. There MAY be a heat sheild over the slave that must be removed before you can get access.

keith
discosaurus

By Petros Machlis (Runnerma) on Friday, October 26, 2001 - 08:59 am: Edit

thanks keith