Cracked manifold[header]

DiscoWeb Message Board: Archives - All topics: 2001 Archive - Technical Discussions: Cracked manifold[header]
  Subtopic Posts   Updated


Top of pagePrevious messageNext messageBottom of pageLink to this message   By gtx on Tuesday, November 20, 2001 - 01:53 pm: Edit

hi guys
has anybody had a cracked manifold on their disco 1?,mines chuffing away from the right hand side sitting behind the wheel.
will this affect mpg,power much?
can they be welded, repaired?
regards gary

Top of pagePrevious messageNext messageBottom of pageLink to this message   By RVR OVR (Tom) on Tuesday, November 20, 2001 - 02:04 pm: Edit

Gary,

This happened to me, it didn't effect MPG very much, but it did effect power when the crack got big. I noticed a difference when I finally fixed it. If replaced mine with a used one.

From what I understand, they can be welded. However, depending on where the crack is, you may need to remove it to weld it. If that is the case, be sure to buy all new gaskets and don't forget the one that bolts on above the catalytic converter.

Tom

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Tuesday Morning on Tuesday, November 20, 2001 - 04:07 pm: Edit

Clean and JB Weld that sumbitch and forget about it. If it works it will work great, if not then worry about pulling the header and dealing with those evil bolts that like to shear off and break or trying to weld that spot. I am easy like that, easy like tuesday morning.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Lester Burnham on Tuesday, November 20, 2001 - 10:56 pm: Edit

Just get it replaced. After you replace that one you will eventually need the other replaced. Then, you shouldn't need them replaced again. From what I have been told, they have a flaw, but the ones they will be replaced with don't. About 350$ to replace them at a non-dealer.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By gtx on Wednesday, November 21, 2001 - 03:57 pm: Edit

Thanks for the info guys,now going to look up jb weld, being English we dont have it over here at least I dont think so.
Regards Gary

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Ron on Wednesday, November 21, 2001 - 04:03 pm: Edit

Gary you should be able to find a set reasonably at a breaker in the UK.

That would probably be most cost effective.

JB Weld is an epoxy resin used to patch metal. Look for something similar over there.

Ron

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Bluegill (Bluegill) on Wednesday, November 21, 2001 - 04:04 pm: Edit

Kyle brought up a good point on the weld fix a while back - you have to eliminate the entire crack before you weld it shut (otherwise crack can continue to propogate even after it's welded up). Use a grinder to completely obliterate that damn crack, THEN weld.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Ron on Wednesday, November 21, 2001 - 04:07 pm: Edit

Helps to drill a hole at the ends of the crack before you weld.

Ron


Posting is currently disabled in this topic. Contact your discussion moderator for more information.

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation