ABS probs need help

DiscoWeb Message Board: Technical Discussions - Discovery: ABS probs need help
  Subtopic Posts   Updated


Top of pagePrevious messageNext messageBottom of pageLink to this message   By Tony R on Tuesday, December 04, 2001 - 10:39 am: Edit

have a '96 Disco and my ABS light comes on and goes outbut usually stays on- also notice under normal braking the ABSsystem seems to go on and pulses the pedal and seems to pull the pedal down and it feels like the car "skips" and you lose your brake pressure - no help from dealers won't talk to me- any info on troubleshooting will be appreciated.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Axel Haakonsen (Axel) on Tuesday, December 04, 2001 - 09:16 pm: Edit

You have a loose or bad ABS sensor. Try to clean and reseat each one.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Daniel on Wednesday, December 05, 2001 - 09:38 am: Edit

Axel,
I had a similar type of problem, which was temporarily fixed by just pushing the sensors down into their seats. It's back, and I'd like to ask if there is a preferred way to get the sensors out. I did pull on them a little bit
when I fooled around with them last time, but I didn't want to break anything. Is there a tool for this, or do I just pull them straight up and out???
Thanks,

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Matt Rigby (Mrigby) on Thursday, December 06, 2001 - 12:48 am: Edit

I have this exact same problem. I have ordered an ABS sensor from Nathan and will see if I can figure out which side is bad. Per Nathan the two front sensors are the same except for the length of the wire, so I ordered the longer one and will try on each side. I have pulled them both out, cleaned and reseated them to no avail. I will post with results.
Matt

Top of pagePrevious messageNext messageBottom of pageLink to this message   By peterb on Thursday, December 06, 2001 - 07:20 pm: Edit

I have also had this problem, May i add that taking your disco to the dealer for 40 bucks is ok to tell you which sensor has gone bad. The fronts seem to go bad first due to the fact that they must twist each time you steer. The dealer will also reset your computer for free after you install your new sensor but you may have to remind them of this! the cumputer can only hold so much info so your most recent problem may not show unless you have it cleared...

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Cal on Thursday, December 06, 2001 - 10:52 pm: Edit

When cleaning and reseating the sensors, is it necessary to replace the bushing ?
Cal

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Peter Thoren on Friday, December 07, 2001 - 11:26 am: Edit

If the bad sensor is in the rear you need to change both sensors since they come as a set together with the cable. After having the dealer checking my Disco with the testbook i know I have to do this. 320£ + VAT from England... The testbook said the right rear sensor was bad. Anyone knows if it is really not possible to change only one sensor in the rear?

TIA

Peter


Add a Message


This is a public posting area. If you do not have an account, enter your full name into the "Username" box and leave the "Password" box empty. Your e-mail address is optional.
Username:  
Password:
E-mail:

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation