DiscoWeb Message Boards
 

Go Back   DiscoWeb Message Boards > Technical Guides and Bulletins > Projects and Tech Guides

Projects and Tech Guides A curated section for member projects and member-produced guides.

Reply
 
Thread Tools Display Modes
  #1  
Old 02-05-2015, 02:05 PM
stu454's Avatar
stu454 stu454 is offline
KN4CBB
Member
 
Join Date: Dec 2004
Location: Atlanta, GA
Posts: 5,305
Member Trucks
I've brought this one over from the old "tech" tab. No author was listed.

Stepper Motor / Idle Air Control Valve (IACV)

Also called the "Idle bypass valve" and "Idle air control motor". This motor is located on the upper plenum of your rover and allows idle air to flow around the throttle plate when its closed.
Its needed because when your foot is not on the gas the throttle plate is completely closed and shuts off air to the engine. If the engine has no air it obviously cannot idle. The "Stepper motor" controls a small pintle that fits into a passage, this passage channels air around the throttle plate. When the motor is retracted the engine idles up, when it extends it idles down. The motor also compensates for engine loads at idle speeds. You turn the A/C on and it drags the motor down, the "Stepper motor" brings the RPM back in range. The same happens when any load hits the engine at idle.

With that said, it should be pretty obvious what the symptoms of a bad or dirty motor are. Your engine will not want to idle. Or it will idle low and stall when a load such as A/C or Power steering.

To service you will have to remove the motor from the plenum and clean the end of the valve. You should also clean the passage that it fits into with carb cleaner. If the symptoms remain after cleaning the motor more then likely needs to be replaced.
Attached Images
File Type: jpg iac.jpg (33.4 KB, 86 views)
File Type: jpg iac2.jpg (30.7 KB, 79 views)
__________________
Stu

'07 LR3
Reply With Quote
  #2  
Old 02-06-2015, 02:43 PM
Levi's Avatar
Levi Levi is offline
Member
 
Join Date: Jul 2004
Location: Cheyenne, WY
Posts: 500
Thought I would add parts cross-references and numbers since you posted this.

DIs
94-95 3.9L Cross Reference w/95 Chevy 1500 with 5.0L.
PN: Napa MPF217388, AC 25527027

96-99 4.0L Cross Reference w/96 Jeep Grand Cherokee 4.0L.
PN: AC 151

The cross references came from old posts I remembered and the parts numbers came from the old tech section.
__________________
98 DI LSE

Last edited by Levi; 02-06-2015 at 05:58 PM.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Log in
User Name Not a member yet?
Register Now!
Password
» Today's Birthdays
jdholder (50)
slowfiveo (34)
Powered by vBadvanced CMPS v3.2.3

All times are GMT -4. The time now is 11:55 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 2000 - 2015, DiscoWeb.org. All rights reserved.

Garage Plus vBulletin Plugins by Drive Thru Online, Inc.