P1316 code after an overheat

Toran

Well-known member
Feb 3, 2017
416
48
Ohio
UPDATE
I got everything all cleaned up and was able to source a pair of clean and reconditioned cylinder heads. Got them installed along with all new gaskets, bolts, and a fuel filter and she fired right up.

This was my first head gasket job. I just took parts off and off and off till I got to the head. The only pain was getting the valley gasket holes to line up on the block. I simply stayed with in until it was done. Fired it up when all complete and it sounded much better. Had a small amount a smoke coming from the manifold, not sure if it was from oil or a possible leak farther down.

In the end I have to once again thank this site for all the helpful threads on this matter.

Thanks!
 

Tugela

Well-known member
May 21, 2007
4,754
561
Seattle
Congrats. Completing that project is no small feat. Glad to hear it went well and here's hoping your work results in a reliable solution for the long term.