Recent content by ColoDisco

The 96 does not have a roto. There is a 2000 but it has a roto.

Thanks everyone! Good news! There are several thirds in the junkyard one with its own propshaft! My question is, will a third from a 96 work? I am assuming yes but I also assumed I could get the roto alignment pin out and we all know how that turned out. As for the tech article maybe add a...

On the bright side there are 6 D1's at the pull and pay! Checking those out in the morning.

Tried and failed at a roto conversion. Need a replacement.

Tried and failed at a roto conversion. Need a replacement.

I have given that some thought. After cooling down I still love her but after 4 months of constant work (camshaft w tappets, TF lift, front drive shaft, Kickdown cable, roof rack strip and paint, front wheel bearings and replacing the alternator twice of which I have done all the work myself) my...

That doesn't help Jake.

This may also be the last repair I make as I am now seriously considering selling it when it is fixed. The conversion tech article on here needs to be changed to reflect that you have to have a puller.

It's done, I need a new 3rd member.

That would be ideal if I had compressed air! :rolleyes: Update, still not there. No way in my lifetime a 24mm socket was fitting in that hole so I am currently trying to grind down the nut so I can remove it in 2 pieces.

Thanks guys! I have seen the tech thread on here and can tell what I am after. Plan today is to Swiss cheese the metal around my 24mm socket so I can fit it in there and remove it. I will post up any updates. BTW, the tech thread on this procedure is not very accurate, the write is by the only...

If I could afford it I would! ;)

At this point I don't care, I just want it off!!

After 4 hours, 2 drill bits broken, 1 punch broken, several beatings with a small sledge and 3 different chisels, 3 different pry bars, heating with a torch, hammering in anger with lots of expletives... ...here is where the cap covering my flange nut currently sits: Tomorrow, round 2! If...

I ordered mine through Land Rover Denver East. They did have to source it and I do not know where they found it. Cost me $115.